TPM-300 Air Quality Module (TPM-300) [S092]

TPM-300 Air Quality Module (TPM-300) [S092]

https://www.youtube.com/watch?v=zHqDCyS7dPU

*GitHub : https://github.com/rdiot/rdiot-s092.git

* Specs

Module type: TPM-300

sensor: the air quality sensor

gas detection: ammonia, hydrogen, alcohol, carbon monoxide, methane, propane, Gan, styrene, propylene 

glycol, alkyl phenol, toluene, ethylbenzene, xylene, formaldehyde and other volatile organic gases, incense smoke, wood, paper burning smoke

physical interface: XH2.54-4 vertical socket

output data: TTL level (built in 200 ohm current limiting resistor)

input voltage: 5 + 0.2VDC (no reverse voltage protection)

working current: less than 80mA

the preheating time: less than 60 seconds

response time: less than 10 seconds

recovery time: less than 20 seconds

operating temperature: -10 - 40 C

the humidity: less than 95%RH

storage temperature: -20 - 60 C

storage humidity: less than 60%RH

dimensions: 24 x 20 x 15 (L * W * H)

module: weight of about 20 grams

sensitivity: 0.5ppm hydrogen

the sensitivity attenuation: less than 1%/ years

: more than 10 years service life

* Contents

- Connect 

B ----- D3

A ----- D2

5V ----- 5V

GND ----- GND

- Level

A              B            Level

Low            Low           0

Low            High          1

High           Low           2

High           High          3

- Key Code 

#include <Wire.h> 

#include <LiquidCrystal_I2C.h>

int pinA = 2; // A

int pinB = 3; // B

LiquidCrystal_I2C lcd(0x27,20,4);  // LCD2004

void setup()

{

  lcd.init();  // initialize the lcd 

  lcd.backlight();

  lcd.print("start LCD2004");

  pinMode(pinA, INPUT);

  pinMode(pinB, INPUT);  

  delay(1000);

  lcd.clear();

}

void loop()

{

 

  lcd.setCursor(0,0);

  lcd.print("S092:TPM-300 Air Q");

  int valueA = digitalRead(pinA);

  int valueB = digitalRead(pinB);

  int airGrade = -1;

  lcd.setCursor(0,1);

  lcd.print("pinA(H/L)=" + (String)valueA + " ");

  

  lcd.setCursor(0,2);

  lcd.print("pinB(H/L)=" + (String)valueB + " ");

  if(valueA == LOW && valueB == LOW)

  {

    airGrade = 0;

  }

  else if(valueA == LOW && valueB == HIGH)

  {

    airGrade = 1;

  }

  else if(valueA == HIGH && valueB == LOW)

  {

    airGrade = 2;

  }

  else if(valueA == HIGH && valueB == HIGH)

  {

    airGrade = 3;

  }

  lcd.setCursor(0,3);

  lcd.print("Air Grade 0~3=" + (String)airGrade + " ");

  delay(300);

}