FTDI Basic Breakout USB-TTL 6 PIN 5V Module (FT232RL) [B091]


* GitHubhttps://github.com/rdiot/rdiot-b091.git

* Specs

This is the newest revision of our FTDI BASIC. It now uses a SMD 6-pin header on the bottom, which makes it smaller and more compact. Functionality has remained the same.

This is a basic breakout board for the FTDI FT232RL USB to serial IC. The pinout of this board matches the FTDI cable to work with official  cloned 5V  boards. It can also be used for general serial applications. The major difference with this board is that it brings out the DTR pin as opposed to the RTS pin of the FTDI cable. The DTR pin allows a target to auto-reset when a new Sketch is downloaded. This is a really nice feature to have and allows a sketch to be downloaded without having to hit the reset button. This board will auto reset any board that has the reset pin brought out to a 6-pin connector.

The pins labeled BLK and GRN correspond to the colored wires on the FTDI cable. The black wire on the FTDI cable is GND, green is CTS. Use these BLK and GRN pins to align the FTDI basic board with your  target.

This board has TX and RX LEDs that make it a bit better to use over the FTDI cable. You can actually see serial traffic on the LEDs to verify if the board is working.

This board was designed to decrease the cost of  for Arduino development and increase ease of use (the auto-reset feature rocks!). Our for Arduino Pro boards and LilyPads use this type of connector.

One of the nice features of this board is a jumper on the back of the board that allows the board to be configured to either 3.3V or 5V (both power output and IO level). This board ship default to 5V, but you can cut the default trace and add a solder jumper if you need to switch to 3.3V. 

Posted by RDIoT

댓글을 달아 주세요

Bluetooth Module HC-05 (HC-05) [S128]


* Specs

30ft Wireless Bluetooth RF Transceiver Module serial RS232 TTL HC-05 for arduino

HC-05 module is an easy to use Bluetooth SPP (Serial Port Protocol) module, designed for transparent wireless serial connection setup.

Typical -80dBm sensitivity

Up to +4dBm RF transmit power

Low Power 1.8V Operation ,1.8 to 3.6V I/O

PIO control

UART interface with programmable baud rate

With integrated antenna

With edge connector

* Contents

PC - FT232RL - HC-05 

Communicate beteween PC and HC-05

'2) Sensor > Bluetooth' 카테고리의 다른 글

Bluetooth 4.0 MP3 Decoding Board Module [B147]  (0) 2016.09.17
HC Serial Bluetooth Module (HC-06) [S018]  (0) 2016.09.17
Posted by RDIoT

댓글을 달아 주세요